Remove the Inside Door Panel on a 2002 Toyota Si..

Sponsored ADS


The Toyota Sienna went without change between 1998 and 2003. The process of Elimination the inside Carry panel is the same for all six models. The Sienna was Reorganized in 2004 with a slightly different Carry panel. If you the need to To replace your Carry speakers or repair your power windows or locks, you'll initially need to to remove the Carry panel.

Sponsored ADS

Sponsored ADS

  • Step 1

    Disconnect the negative (black) battery cable. To disconnection the cable, To loosen itself the nut attache to the cable and traction the cable far from the terminal.

  • Step 2

    Remove the courtesy lamp objective at the Back section of the Carry panel. You can pry the objective off with a dish head screwdriver.

  • Step 3

    Remove the two screw Hats from inside of the Carry panel armrest. to remove the Screw behind the Hats and slide the Balustrade off.

  • Step 4

    Pry off the Balance panel behind the inside Carry handle. to remove the Philips screw behind the panel.

  • Step 5

    Pry up the power Fenestrate control panel with a dish head screwdriver. To take down the wiring harness of behind it.

  • Step 6

    Use the Carry trim panel tool to disengagement the fasten that attaches the Carry panel to the door. The 2002 Sienna has seven clips. Two of they are on each one side and three are
    bottom. insertion the tool enter the panel and the Carry and pushed back to disengagement the clips.

  • Step 7

    Carefully traction the panel far from the Carry and set it aside.

    		•  Sponsored ADS