Use Jack Stands on a Truck..

Sponsored ADS


While use jack stands on trucks or any other convey seems like simple commun run sense, abuse or not payment attention to detail can wire to dangerous or mortal conditions. All jacks and jack stands device weight limitations; never use a jack on a truck that is heavier that the weight limit of the jack. Where you place the jack stands and how you use other safety equipment is too extremely important.

Sponsored ADS

Sponsored ADS

  • Step 1

    Park the truck on a level and paving stone ground.

  • Step 2

    Apply the parking brake; but to include/understand that if the Back axle is lifted, the parking brake catch will be ineffective.

  • Step 3

    Place Coil wedges in front and behind the same tire on the opposed axle you to envisage to elevator and suspend on floor jacks. This is an additional measure to to prevent the truck of moving while you are under it.

  • Step 4

    Use the adapted weight-rated jack to elevator one corner of the center you're lifting at a time. The front braces rail or inferior control arm and the Back axle or inferior shock Frames are usually sure lift points for majority trucks.

  • Step 5

    With the corner raised, place the correctly weight-rated jack stand under the truck. If use the front order arm, place the jack stand under the front braces rail. to make sure the inferior control arm Fact not suspend at an angle on the front tire and cause unequal placement on the jack stand when support the truck.

  • Step 6

    When to increase the rear, place the jack stand(s) below the Back axle. to make sure the sit of the jack stand is far from any steel brake lines so they are not damaged. You can to increase the jack stand by traction up on the arm seats to the wished level. Be sour each jack stand on the same center is set in equal height.

  • Step 7

    Lower the corner of the truck slowly. repetition the process for the opposed side of the axle. If you are lifting all four corners, beginning in the front with the parking brake of the truck applied, and use four Coil wedges to lock one front and one Back wheel of both sides.

  • Step 8

    When you're loan to inferior the truck to the ground, slightly elevator the jack, one corner at a time, then to remove the adapted jack stand. Slowly inferior the jack Then the jack stand is removed; repetition the process for the opposed jack stand on the same axle. If lifting all four corners of the truck, inferior the Back first, with the parking brake applied, and then inferior the front.

    		•  Sponsored ADS